Bath Fun Kids Soap Kit

Instructions to create your soap using our "Bath Fun" Kids Soap Kit found here.

Preparation

Ask an adult for help and supervision!

Give your mould and melting jug a good clean if required. Rinse them with hot water and allow them to fully air dry before use (or use a lint-free cloth).

Step #1

Put on your pair of black gloves to protect your hands.

Empty one of your pouches of goat's milk soap base into the plastic pouring jug.

Step #2

Add in one of your colour blocks. If you would like a lighter colour than mine, you can easily cut this to use less.

Step #3

Microwave your soap base and colour block for 30 seconds only.

Stir your soap base after 30 seconds in the microwave, using your large wooden stirrer.

Step #4

Continue to microwave in 20-30 second bursts, mixing well after each burst, until all lumps have fully melted. Do not microwave any more than necessary to avoid burning your base.

Step #5

Take one bottle of your monkey farts fragrance oil and pour this into your soap mix.

Step #6

Stir to combine well for approximately 1-2 minutes. Stir gently to avoid introducing too many bubbles to the mix.

Step #7

Gently and slowly pour your soap mix into your choice of 4 of the mould shapes.

Step #8

As soon as you have poured this soup into the mould, spray the surface with your rubbing alcohol. This is crucial to pop the surface bubbles and ensure a flat base for your soaps.

Step #9

Empty a second pouch of goat's milk soap base into the plastic pouring jug. Add your second colour block (or less if desiring a paler shade).

Step #10

Repeat steps 3-6 above with your next colour soap mix.

Step #11

Once you have your melted base, and have added your fragrance, gently pour your pink soap base into your choice of 4 mould shapes.

Step #12

As soon as you have poured this soup into the mould, spray the surface with your rubbing alcohol. This is crucial to pop the surface bubbles and ensure a flat base for your soaps.

Step #13

Empty the final pouch of goat's milk soap base into the plastic pouring jug. Add your final colour block (or less if desiring a paler shade).

Step #14

Repeat steps 3-6 above with your final colour soap mix.

Step #15

Once you have your melted base, and have added your fragrance, gently pour your pink soap base into your choice of 4 mould shapes.

Step #16

As soon as you have poured this soup into the mould, spray the surface with your rubbing alcohol. This is crucial to pop the surface bubbles and ensure a flat base for your soaps.

Step #17

Allow your soap to set for a few hours to overnight. Gently remove the soaps from your mould. The soaps will harden a little more if you leave them for a week to cure, however, they are safe to use immediately.

Lather and enjoy!